Difference between revisions of "Slicer Profiles"

From MakeICT Wiki
Jump to navigationJump to search
Line 11: Line 11:
 
=== Current ===
 
=== Current ===
 
*Download file: [https://drive.google.com/open?id=19IaIPBA8IXpZhsH5y__BsfXCHexf_7VI 2018-12-20_MakeICT_Slic3r_config_bundle.ini]
 
*Download file: [https://drive.google.com/open?id=19IaIPBA8IXpZhsH5y__BsfXCHexf_7VI 2018-12-20_MakeICT_Slic3r_config_bundle.ini]
 +
=== Vendor Profiles ===
 +
You can also install the vendor profiles so that your settings will be updated automatically. Instructions pending.

Revision as of 16:58, 20 December 2018

Below are the default slicer profiles for the 3d printers at MakeICT.

Slic3r

To use these files:

  1. Download Slic3r Prusa Edition
  2. Run Slic3r
  3. Download the current config bundle on this page
  4. File -> Load Config Bundle
  5. Select downloaded config file
  6. Check back here for updates

Current

Vendor Profiles

You can also install the vendor profiles so that your settings will be updated automatically. Instructions pending.