Difference between revisions of "Slicer Profiles"

From MakeICT
Jump to: navigation, search
Line 3: Line 3:
 
== Slic3r ==
 
== Slic3r ==
 
To use these files:
 
To use these files:
#[https://github.com/prusa3d/Slic3r/releases Download Slic3r Prusa Edition]
+
#[https://www.prusa3d.com/drivers/ Download PrusaSlicer]
#Run Slic3r
+
#*From the section labeled "Drivers & Apps"
 +
#Run the installer
 +
#*Select only the first option, unless you want to install other components
 +
=== Vendor Profiles ===
 +
 
 +
 
 
#Download the current config bundle on this page
 
#Download the current config bundle on this page
 
#File -> Load Config Bundle
 
#File -> Load Config Bundle
Line 11: Line 16:
 
=== Current ===
 
=== Current ===
 
*Download file: [https://drive.google.com/open?id=19IaIPBA8IXpZhsH5y__BsfXCHexf_7VI 2018-12-20_MakeICT_Slic3r_config_bundle.ini]
 
*Download file: [https://drive.google.com/open?id=19IaIPBA8IXpZhsH5y__BsfXCHexf_7VI 2018-12-20_MakeICT_Slic3r_config_bundle.ini]
=== Vendor Profiles ===
 
You can also install the vendor profiles so that your settings will be updated automatically. Instructions pending.
 

Revision as of 09:38, 21 August 2019

Below are the default slicer profiles for the 3d printers at MakeICT.

Slic3r

To use these files:

  1. Download PrusaSlicer
    • From the section labeled "Drivers & Apps"
  2. Run the installer
    • Select only the first option, unless you want to install other components

Vendor Profiles

  1. Download the current config bundle on this page
  2. File -> Load Config Bundle
  3. Select downloaded config file
  4. Check back here for updates

Current