Slicer Profiles

From MakeICT Wiki
Revision as of 04:38, 21 August 2019 by Christian Kindel (talk | contribs)
Jump to navigationJump to search

Below are the default slicer profiles for the 3d printers at MakeICT.

Slic3r

To use these files:

  1. Download PrusaSlicer
    • From the section labeled "Drivers & Apps"
  2. Run the installer
    • Select only the first option, unless you want to install other components

Vendor Profiles

  1. Download the current config bundle on this page
  2. File -> Load Config Bundle
  3. Select downloaded config file
  4. Check back here for updates

Current