Difference between revisions of "Tormach CNC Mill"
From MakeICT Wiki
Jump to navigationJump to searchSam Schurter (talk | contribs) (→Links) |
Curt Gridley (talk | contribs) m (Added link to Tormach Access Policy) |
||
| Line 5: | Line 5: | ||
*[http://www.destinytool.com/speeds--feeds.html Feeds and Speeds Calculator] | *[http://www.destinytool.com/speeds--feeds.html Feeds and Speeds Calculator] | ||
*[http://www.bellforestproducts.com/info/janka-hardness/ Wood Hardness reference] | *[http://www.bellforestproducts.com/info/janka-hardness/ Wood Hardness reference] | ||
| + | *[http://makeict.org/wiki/Tormach_Access_Policy Tormach Access Policy] | ||
===Useful Gcode Commands=== | ===Useful Gcode Commands=== | ||
Revision as of 14:16, 16 January 2018
This document is not a replacement for training or authorization. Do not attempt to use the Tormach without proper training.
Contents
Resources
Links
Useful Gcode Commands
- G0[axis][coordinate] Does a rapid move along the axis to the specified coordinate. You can supply multiple axes in one command. Example: G0X1.000Y0.000Z-0.0150 or G0Z-0.050
- G1[axis][coordinate] Same as G0, but limits speed to the feedrate.
Tool Reference
| Tool Name | Fusion Library # | Radius | Flutes | Materials |
|---|---|---|---|---|
| Tormach SuperFly Cutter |
Rules
- Do not leave chuck empty.
- Do not leave a tool in a dangerous state.
Basic Operation
Squaring the Vise
Info plz?
Squaring a Block in Manual Mode
- Turn on the air compressor and drain the condensate.
- Plug in the Tormach lights
- Turn on the large red master switch on the left side of the machine
- Wait for the computer to boot. If it hangs, cycle the power.
- Turn the e-stop button on the front to pop it out and press the green button beside it
- Press the flashing "Reset" button on the PathPilot software.
- Home the Z axis by pressing 'Ref Z'. Then, home the x and y axes by pressing 'Ref X' and 'Ref Y'.
- Install the bit you want and check RPM and Feedrate settings.
- Set workpiece using vise, clamps, and parallels as necessary.
- Z-down and set height to barely contact the workpiece.
- Position x and y for the first pass. Make sure the bit will not come into contact with the workpiece
- Zero all axes
- Close the doors and do a final check to make sure no tools are in the way.
- Press "FWD" to start the spindle
- Z-down to the depth of the first pass
- Use the jog shuttle to cut the first pass. Repeat as necessary to finish the side.
- Press "Stop" to stop the spindle.
- Reposition the workpiece and repeat for the remaining sides.
- Brush down the vise and table. Oil if needed.
- Press "Exit"
- Push in the e-stop and press "OK".
- Turn off master switch.
- Unplug lights.
- Turn off compressor.
